My recent purchase of a Genie Intellicode Garage door opener was a wireless pad that I use, equipped for the door could be opened without using the remote control. Since this pad is a wireless device, the installation is very simple. I just got support for the pad and screwed into the side of the pole out of my garage door.
The pad is small and fits well in the area that I put. Its discreet, but still significant. After installing the pad, then Ito program it. The unit came with a set of directions very instructive to understand that both the installation and programming is simple and run. They're just a garage so I just need a code for radio stations using the set of basic programming instructions.
I had to open the lid all the way and wait to flash on the display once and then go blank. Then I had the numbers three, five and seven type, and press the PROG button. Button. The displayLight began to blink once per second. Following the instructions included with the genius, then I in my own personal PIN number for the port monitor. The PIN can consist of up to eight digits.
After entering the number, I pressed the PROG button again and the LED starts to flash at a rate of twice per second. At this stage in the directions that I cover and the program needed to close the garage door opener, genius itself. The code of the key learningGarage door opener was on my back and the device was simple and easy to find.
I pressed the button to learn the code and get the code LED started to blink. Following the instructions I then entered the PIN number I had used on the keyboard and press the ENTER key four times. My garage door has gone as it should. The installation of this keyboard I had less than 10 minutes from when I did it out of the box at the time when I had to work on it. TheDirections were clear and concise, and I would recommend this product to anyone.
0 comments:
Post a Comment